How To Replace Battery In Key Fob Jeep Grand Cherokee

Among the most popular Jeep brand vehicles of the 1990s the Grand Cherokee enjoyed a long run featuring the manufacturers top technologies and innovations.

How to replace battery in key fob jeep grand cherokee. How to Replace Battery in Jeep Key Fob. However there are ways of programming your key fob that is available. Bottom half of the FOB contains the CR2032 coin battery.

You could reprogram a key fob to a different vehicle as long as the key is the same for the vehicle. It will start the car but as far as locking the doors and popping open the hatch glass its DEAD. Replace the battery following the polarity with the positive side to the body of the FOB.

Remove the battery cables from the vehicle wait 30 seconds then hook them back up reset computer. These systems allow drivers to remotely control their vehicle from as far as a couple hundred feet. Insert the new CR2032 3-volt battery with the positive side facing down into the rear cover of the key fob.

This can be done either by loosening the screw on the back of the key fob or using a small flathead screwdriver to pry open the fob using the seam in the middle of the fob. Insert the ignition key back into the top and test out the key fob. Among these technologies introduced in the 1990s was the keyless entry remote system.

Can you program a new key fob yourself. Remove the battery by pulling it out of the holder pushing it gently against the spring contacts. GQ4-54T - Order Herehttpsbitly2Wg96MwBATTERY.

Turn the key to the Run position and aim the keyless remote at the steering wheel. Insert the flathead screwdriver into the key fob seam near the keyring mount. Once open youll find a small circuit board a rubber keypad and the battery.